ABB ACS880 - ESP Control

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
Enables ESP function parameters.ESP control74
- / unit16Defines the control source for the primary ESP control
program functions.
ESP control word74.1
By default, most of the ESP function enable parameters
use ESP control word as a source.
Note: If the user chooses to use different control source
for a certain function, this control word setting will
have no effect for that particular function.
Reservedb0
Enables restart delay function.Restart delayb1
Enables backspin speed observer function.Backspin speed
observer
b2
Reservedb3
Enables acceleration assistance function.Acceleration
assistance
b4
Enables kick-start function.Kick-startb5
Enables current-pulse start function.Current pulse startb6
Enables underload protection function.Underload
protecdtion
b7
Enables overload protection function.Overload protectionb8
Enables energy optimizer function.Energy optimizerb9
Enables U/f voltage curve function.U/f voltage curveb10
Enables IR-compensation.IR-compensationb11
Enables pump cleaning function.Pump cleaningb12
Reservedb13
Enables auto mode enable function.Auto mode enableb14
Enables time control function.Time controlb15
1 = 10000h…FFFFh
ESP CW bit 1 / unit32Defines the source for Restart delay function enable
signal.
Restart delay enable74.20
The restart delay function inhibits user start command
for the time set in parameter 74.21 Restart delay time.
For further information on Restart delay, see section
Restart delay .
0Restart delay enable signal is disabled.Not selected
1Restart delay enable signal is enabled.Selected
2Digital input DI1 (10.2 DI delayed status, bit 0).DI1
3Digital input DI2 (10.2 DI delayed status, bit 1).DI2
4Digital input DI3 (10.2 DI delayed status, bit 2).DI3
5Digital input DI4 (10.2 DI delayed status, bit 3).DI4
6Digital input DI5 (10.2 DI delayed status, bit 4).DI5
Parameters 519