Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
Defines the data sent to the DDCS link.D2D and DDCS
transmit data
61
See also parameter group 60 DDCS communication.
Follower CW / uint32Preselects the data to be sent as word 1 onto the
master/follower link.
M/F data 1 selection61.1
See also parameter 61.25 M/F data 1 value, and section
General (page 72).
0None.None
1Control Word (16 bits)CW 16bit
4Status Word (16 bits)SW 16bit
5Actual value ACT1 (16 bits)
Note: Using this setting to send a reference to the
follower is not recommended as the source signal is
filtered. Use the “reference” selections instead.
Act1 16bit
6Actual value ACT2 (16 bits)
Note: Using this setting to send a reference to the
follower is not recommended as the source signal is
filtered. Use the “reference” selections instead.
Act2 16bit
27A word consisting of bits 0…11 of 6.1 Main control word
and the bits selected by parameters 06.45…06.48.
Follower CW
Note: Bit 3 of the follower control word is kept on as
long as the master is modulating, and when it switches
to 0, the follower coasts to a stop.
614524.1 Used speed reference (page 318).Used speed
reference
673126.75 Torque reference act 5 (page 346).Torque reference act
5
665826.2 Torque reference used (page 338).Torque reference
used
28A follower status word compatible with an ACS800
(System Control Program) master. With this setting,
ACS800 System ctrl
SW
status word bit 0 is cleared whenever the run enable
signal is missing.
29Otherwise identical to selection Follower CW, but bit
6 of the follower control word is also kept on as long
Follower CW B6 high
as the master is modulating. This will allow the follower
to stop along the stop ramp of the master.
809013Virtual address for Control word for the follower units,
bit 6 high as long as the drive modulates
Follower CW B6 high
Note: This setting cannot be used in 61.03 M/F data 3
selection because the 32-bit value requires two
consecutive words.
Parameters 505
To Next Page
Loading...
