ABB ACS880 - Page 520

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
7Digital input DI6 (10.2 DI delayed status, bit 5).DI6
10Digital input/output DIO1 (11.2 DIO delayed status, bit
0).
DIO1
11Digital input/output DIO2 (11.2 DIO delayed status, bit
1).
DIO2
12Parameter 74.1 ESP control word (page 519), bit 1 status
controls enable/disable status of the function.
ESP CW bit 1
See Terms and abbreviations (page 169).Other [bit]
0.0 min / real32Defines restart delay time.
The timer gets active immediately after stop command
is enabled.
Restart delay time74.21
10 = 1 min / 10 = 1
min
Restart delay time.0.0 ... 30000.0 min
Not selected / unit32Enables automatic restart and restores the previous
reference and drive status (start/stop) after a power
failure.
The automatic restart functions only if the power
resumes before the time mentioned in parameter 74.25
Automatic restart time limit.
For more information on ESP automatic restart, see
section Automatic restart .
Automatic restart74.24
00Not selected
11Selected
2Digital input DI1 (10.2 DI delayed status, bit 0).DI1
3Digital input DI2 (10.2 DI delayed status, bit 1).DI2
4Digital input DI3 (10.2 DI delayed status, bit 2).DI3
5Digital input DI4 (10.2 DI delayed status, bit 3).DI4
6Digital input DI5 (10.2 DI delayed status, bit 4).DI5
7Digital input DI6 (10.2 DI delayed status, bit 5).DI6
10Digital input/output DIO1 (11.2 DIO delayed status, bit
0).
DIO1
11Digital input/output DIO2 (11.2 DIO delayed status, bit
1).
DIO2
See Terms and abbreviations (page 169).Other [bit]
0 min / real32Defines the time limit for automatic restart.Automatic restart
time limit
74.25
1 = 1 min / 1 = 1 minAutomatic restart time limit. Drive restarts
automatically only if power resumes before the defined
time.
0...30000 min
520 Parameters