ABB ACSM1 - Page 100

Parameters and firmware blocks
100
8.06 ALARM WORD 2 FW block: FAULT FUNCTIONS (page 173)
Alarm word 2. For possible causes and remedies, see chapter Fault tracing.
8.07 ALARM WORD 3 FW block: FAULT FUNCTIONS (page 173)
Alarm word 3. For possible causes and remedies, see chapter Fault tracing.
8.08 ALARM WORD 4 FW block: FAULT FUNCTIONS (page 173)
Alarm word 4. For possible causes and remedies, see chapter Fault tracing.
Bit Alarm
0 IGBT OVERTEMP
1 FIELDBUS COMM
2 LOCAL CTRL LOSS
3 AI SUPERVISION
4 Reserved
5 NO MOTOR DATA
6 ENCODER 1 FAILURE
7 ENCODER 2 FAILURE
8 LATCH POS 1 FAILURE
9 LATCH POS 2 FAILURE
10 ENC EMULATION FAILURE
11 FEN TEMP MEAS FAILURE
12 ENC EMUL MAX FREQ
13 ENC EMUL REF ERROR
14 RESOLVER AUTOTUNE ERR
15 ENCODER 1 CABLE
Bit Alarm
0 ENCODER 2 CABLE
1 D2D COMMUNICATION
2 D2D BUF OVLOAD
3 PS COMM
4 RESTORE
5 CUR MEAS CALIBRATION
6 AUTOPHASING
7 EARTH FAULT
8 Reserved
9MOTOR NOM VALUE
10 D2D CONFIG
11…14 Reserved
15 SPEED FEEDBACK
Bit Alarm
0 OPTION COMM LOSS
1…15 Reserved