Parameters and firmware blocks
76
Note: Pointing to a nonexisting bit will be interpreted as 0 (FALSE).
For additional parameter data, e.g. update cycles and fieldbus equivalents, see
chapter Parameter data.
Firmware blocks
Firmware blocks accessible from the DriveSPC PC tool are described in the
parameter group most of the block inputs/outputs are included in. Whenever a block
has inputs or outputs outside the current parameter group, a reference is given.
Likewise, parameters have a reference to the firmware block they are included in (if
any).
Note: Not all parameters are available through firmware blocks.
1 Inputs
2 Outputs
3 Input parameter values
4 Pointer parameter indicator “<“
5 Parameter 26.01 is set to value P.1.1, i.e. signal 1.01 SPEED ACT. The “7” means the signal can be
found on page 7 of DriveSPC.
6 ID of the time level (TL4) and time level (250 µs). Time level, i.e. update cycle, is application-specific.
See the time level of the block in DriveSPC.
7 Firmware block ID number in the application program
8 Firmware block execution order for the selected update cycle ID
2
3
6
7
8
4
5
1
To Next Page
Loading...
