6 FOX615Installation
Figure 40: Molex connector frame alarm signal inputs 67
Figure 41: DUPF1 alarm interface connection 68
Figure 42: FAMO1 and FAMO1-F alarm signals output interface 69
Figure 43: Molex connector frame system alarm signal outputs 69
Figure 44: Alarm output contact scheme (no alarms, inactive state) 70
Figure 45: Alignment of the heat deflection shield for evacuation of heated air to the rear 71
Figure 46: Alignment of the heat deflection shield for evacuation of heated air to the front 72
Figure 47: Cable clamps and earthing bars (conductive foam in bars and clamps is dark shaded) 73
Figure 48: Detail of unlocking a cable clamp with a screwdriver (application with left clamp shown) 74
Figure 49: Mounting of three plus three EMC clips to the earthing bars 75
Figure 50: Insertion of units in the subrack 77
Figure 51: Removal of units from the subrack 79
Figure 52: Installing the front cover to the subrack 81
Figure 53: Removing the front cover from the subrack 83
To Next Page
Loading...