ABB FOX615 - Page 7

FOX615Installation 5
Figures
Figure 1: FOX615 power distribution 14
Figure 2: Evacuation of heated air to the rear (recommended for 19-inch installation at the bottom of a cab-
inet) 17
Figure 3: Evacuation of heated air to the front (recommended for 19-inch installation at the top of a cabinet)
18
Figure 4: Arrangement of stacked FOX with heat deflection devices 19
Figure 5: Earthing and power supply terminals of the FOX615 subrack 21
Figure 6: 19-inch installation standard for the FOX615 24
Figure 7: Mechanical dimensions FOX615 subrack 25
Figure 8: Mechanical dimensions FOX615 subrack with front cover and DUPF1 26
Figure 9: Mechanical dimensions DUPF1 dual power supply connection box (option) 26
Figure 10: Mechanical dimensions FOX615 cable tray 27
Figure 11: Mechanical dimensions FAMO1 fan unit 27
Figure 12: Mechanical dimensions FAMO1-F fan unit 28
Figure 13: Mechanical dimensions heat deflection shield 2 HU 28
Figure 14: Mechanical dimensions heat deflection shield 1 HU 29
Figure 15: ETSI installation standard for the FOX615 30
Figure 16: 11 HU adapter for the installation of the cable tray, subrack, fan unit and heat deflection shield in
ETSI racks (left side adapter shown only) 32
Figure 17: 9 HU adapter for the installation of the cable tray, subrack and fan unit in ETSI racks (left side
adapter shown only) 33
Figure 18: 2 HU adapter for the installation of the heat deflection shield in ETSI racks (left side adapter shown
only) 33
Figure 19: Subrack packing assembly of the FOX615 37
Figure 20: FOX615 installation with 11 HU ETSI adapters 39
Figure 21: FOX615 fixing positions in the 19-inch rack relative to the cable tray 41
Figure 22: Cable tray 42
Figure 23: FOX power supply cable 43
Figure 24: Cable tray and installation of WAGO connector blocks and power cables 44
Figure 25: Connecting wires to the WAGO connector block 45
Figure 26: Cable with ferrite toroid sample 47
Figure 27: Cable with EMC filter sample 47
Figure 28: Installation and position of connectors and cables with EMC filter with respect to the front line of
the cable tray 48
Figure 29: DUPF1 installation 53
Figure 30: FOX subrack with DUPF1 installed 55
Figure 31: FOX subrack FAMO1 or FAMO1-F power and alarm cable installation 56
Figure 32: Earthing / bonding points of the FOX subrack 59
Figure 33: Principles of single circuit power supply 61
Figure 34: Principles of two circuits power supply 62
Figure 35: FAMO1 or FAMO1-F power and alarm cable 64
Figure 36: Installation of the FAMO1 or FAMO1-F power and alarm cable 65
Figure 37: FAMO1 and FAMO1-F alarm interfaces 66
Figure 38: Molex connector frames and crimp terminals 66
Figure 39: FAMO1 and FAMO1-F alarm signals input interfaces 67