Required equipment
NoteArticle numberEquipment
3HAC053662-003Fork lift accessory
Content is defined in section Standard
toolkit on page 833.
-Standard toolkit
Inspecting, fork lift device set
NoteAction
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot working area.
1
Inspect the fork lift accessory pockets for damage.2
Inspect the attachment screws for deformation and
other type of damage.
3
Tightening torque: 300 NmMake sure the fork lift pockets are properly attached
(4 pcs).
4
Article number is specified in
Required equipment on page 134.
If any damage is detected, the fork lift pockets and
attachment screws must be replaced.
5
Attachment screws: M20x60
quality steel 8.8-A3F
Product manual - IRB 8700 137
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
3 Maintenance
3.3.13 Inspecting the fork lift accessories
Continued
To Next Page
Loading...
