ABB IRB 8700 Series - Replacing the Process Turning Disc

4.5.5 Replacing the process turning disc
Location of the process turning disc
The process turning disk is located as shown in the figure.
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest revision of Product manual, spare parts - IRB 8700on ABB Library.
NoteArticle numberSpare part
3HAC051003-005Process turning disc
Required tools and equipment
NoteArticle numberEquipment, etc.
Lifting capacity: 1,000 kg-Roundsling 1 m
Content is defined in section Standard
toolkit on page 833.
-Standard toolkit
Removing the process turning disc
Use these procedures to remove the process turning disc.
Preparations before removing the process turning disk
NoteAction
Jog the robot to a comfortable position for
removing the process turning disk.
1
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot
working area.
2
Remove any tools or other equipment (in-
cluding the DressPack) fitted to the process
turning disk.
3
Continues on next page
346 Product manual - IRB 8700
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
4 Repair
4.5.5 Replacing the process turning disc