3.4.2 Changing oil, axis-1 gearbox
Usage of dispenser
The oil change procedure in this section describes usage of an oil dispenser.
Location of oil plugs
The oil plugs of the gearbox are located as shown in the figure.
xx1500002011
Ventilation plug (can also be used for filling oil, when not
using an oil dispenser)
Top right
Inspection plugBottom right
Draining and filling (fitted with nipple intended for use of a
oil dispenser when filling or draining oil)
Left
Required consumable
NoteMaterial
Information about the oil is found in Technical refer-
ence manual - Lubrication in gearboxes.
Lubricating oil
See Type and amount of oil in gearboxes on page 140.
Required tools and equipment
NoteArticle numberEquipment, etc.
The capacity of the vessel must be
sufficient to take the complete amount
of oil.
-Oil collecting vessel
Continues on next page
Product manual - IRB 8700 141
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
3 Maintenance
3.4.2 Changing oil, axis-1 gearbox
To Next Page
Loading...
