3.4.4 Changing oil, axis-4 primary gearbox
Usage of oil dispenser
The oil change procedure in this section describes usage of an oil dispenser.
Location of oil plugs
The oil plugs of the gearbox are located as shown in the figure.
xx1500002015
xx1500002016
• Left = Ventilation hole
• Right = Inspection hole
Oil filling and draining hole, with nipple.
Used with an oil dispenser.
Tightening torque: 24 Nm.Tightening torque: N/A.
Required consumable
NoteMaterial
Information about the oil is found in Technical refer-
ence manual - Lubrication in gearboxes.
Lubricating oil
See Type and amount of oil in gearboxes on page 140.
Required tools and equipment
NoteArticle numberEquipment, etc.
The capacity of the vessel must be
sufficient to take the complete amount
of oil.
-Oil collecting vessel
One example of oil dispenser can be
found in section Type of lubrication in
gearboxes on page 140.
-Oil dispenser
Content is defined in section Standard
toolkit on page 833.
-Standard toolkit
Required documents
NoteDocument numberDocument name
3HAC042927-001Technical reference manu-
al - Lubrication in gearboxes
Continues on next page
Product manual - IRB 8700 153
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
3 Maintenance
3.4.4 Changing oil, axis-4 primary gearbox
To Next Page
Loading...
