ABB IRB 8700 Series - Refitting the Cable Harness

4.4.2 Refitting the cable harness
Location of the cable harness
The cable harness is located as shown in the figure.
xx1500001878
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest revision of Product manual, spare parts - IRB 8700 on ABB Library.
NoteArticle numberSpare part
3HAC050792-001Cable harness
Required tools and equipment
NoteArticle numberEquipment, etc.
Content is defined in section Standard
toolkit on page 833.
-Standard toolkit
Used to remove and refit the R1.SMB
in the base.
-Sparkplug wrench
Continues on next page
Product manual - IRB 8700 215
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
4 Repair
4.4.2 Refitting the cable harness