NoteAction
Make sure that the axis-5 is as close to
+90° or -90° position as possible, depend-
ing on what repair work is being done.
Note
Not needed if only replacing the axis-6 unit.
2
xx1200001080
Unscrew the attachment screws and re-
move the motor cover.
Note
Do not damage the gasket. Replace if
damaged.
3
xx1300000488
Disconnect the motor cables.4
xx1300000484
Unscrew the attachment screws holding
the cable bracket.
5
Continues on next page
Product manual - IRB 8700 201
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
4 Repair
4.4.1 Removing the cable harness
Continued
To Next Page
Loading...
