NoteAction
xx1200001070
Note
Make sure the o-ring is not lost when remov-
ing the cover.
3
xx1200001066
Disconnect the motor cables.4
xx1200001067
Remove the cable gland cover.
Inspect the gasket.
Note
Replace if damaged.
Tip
Make a note in which direction the cable
exit hole is facing, if the motor will be re-
moved too. The motor shall be refitted in
the same position.
5
Use caution and pull out the motor cables.6
Removing the cable harness in the upper arm
NoteAction
DANGER
Make sure that all supplies for electrical
power, hydraulic pressure, and air pressure
are turned off.
1
Continues on next page
Product manual - IRB 8700 205
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
4 Repair
4.4.1 Removing the cable harness
Continued
To Next Page
Loading...
