NoteAction
xx1300000731
Use caution and remove the SMB unit.6
ESD bagKeep the SMB unit in an ESD bag until it shall be re-
fitted.
7
Refitting the SMB unit
Use these procedures to refit the SMB unit.
Refitting the SMB unit
NoteAction
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
1
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the
unit please read the safety information in the
section The unit is sensitive to ESD on page 32
2
xx1300000729
Connect the battery cable to the SMB unit.
Make sure the lock snaps into place during refit-
ting.
3
Continues on next page
238 Product manual - IRB 8700
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
4 Repair
4.4.3 Replacing the SMB
Continued
To Next Page
Loading...
