Tension Electronics PFEA113, User Manual
Section 3.8.1 Performing Fast Setup using Hanging Weights
3BSE029382R0101 Rev C 3-7
NOTE
When using HangWeight the wrap gain value is calculated by the tension
electronics.
To be able to read the wrap gain value, go to menu EnterWrapGain of the desired
roll.
9 Select the load cells (2, SingleSideA or SingleSideB) that
support the roll from the list with or . Confirm with .
10 Check the nominal load on the load cell name plate.
Select nominal load from the list with or .
Confirm with .
11 1. Apply a known weight on the roll (see Figure 3-1).
2. Enter the value of the known weight. Confirm with .
12
Select Voltage or Current from the list with or .
Confirm with .
13 Voltage selected:
Enter the tension value corresponding to 10 V.
or
Current selected:
Enter the tension value corresponding to 20 mA.
Confirm with .
14 Select filter setting (5, 15, 30, 75, 250, 750 or 1500 ms) from
the list with or . Confirm with .
15 FastSetUp of a system with one roll is now completed.
Press to finish the fast setup and go to the operator
menu.
Proceed with the FastSetUp for Roll 2. In step 4, select the
load cells (2, SingleSideC or SingleSideD) that support
Roll 2 from the list with or . Confirm with .
NominalLoad
[1 kN 225 lbs]
SetTensionAt10V
[XXXXXX] N
SetTensionAt20mA
[XXXXXX] N
FilterSettings
[250 ms 1.5Hz]
Finished
PressOk
To
Operator
Menu
To Next Page
Loading...
