ABB PFEA 113 - Chapter 4 Operation; 4.2 Safety Instructions; 4.3 Operating Devices

Tension Electronics PFEA113, User Manual
Section 4.1 About this Chapter
3BSE029382R0101 Rev C 4-1
Chapter 4 Operation
4.1 About this Chapter
Your measurement system does not need any attention during normal operation. Measurement
runs continuously as long as the system is switched on. However, you need to know how to start
and shut down the system, see Section 4.4 Start-up and shut-down.
4.2 Safety Instructions
Read and follow the safety instructions given in Chapter 1 Introduction, before starting any
operation work. However, local statutory regulations, if stricter, are to take precedence.
4.3 Operating Devices
The LED-indicators and operator keys are described in Figure 4-1.
Figure 4-1. Operating Devices
Power Status
Backlit LCD display
Step back Step downStep up OK (acknowledgment)
LED “Status”LED “Power”
or cancel