ABB PFEA 113 - Appendix H Actual Data and Settings at Commissioning

Tension Electronics PFEA113, User Manual
Section H.1 Document the Commissioning in this Form
3BSE029382R0101 Rev C H-1
Appendix H Actual Data and Settings at Commissioning
H.1 Document the Commissioning in this Form
Fill in actual data and settings to document the commissioning.
Display language
Display unit N, kN, kg, lbs, N/m,
kN/m, kg/m, pli
Web width m, inch
System Definition ONE ROLL
Gain scheduling Yes No
Object type Standard roll
Single side
Load cell nominal load kN, lbs
Wrap gain 1
Wrap gain 2
TWO ROLLS
Gain scheduling Yes No
Roll 1 Object type Standard roll
Single side
Load cell nominal load kN, lbs
Wrap gain 1
Wrap gain 2
Roll 2 Object type Standard roll
Single side
Load cell nominal load kN, lbs
Wrap gain 1
SEGMENTED ROLL
Gain scheduling Yes No
Segmented Roll Scale Factor (SRSF)
Object type One input
Two inputs
Three input
Four inputs
Load cell nominal load kN, lbs
Wrap gain 1
Wrap gain 2
If HangWeight has been used at commissioning, go to menu “EnterWrapGain”, read the
Wrap gain value calculated by the electronics and fill in this Wrap gain value in the table.