ABB PFEA 113 - Wrap Gain Menus for One Roll, Two Rolls and Segmented Roll

Tension Electronics PFEA113, User Manual
Section 3.12.6 Set Wrap Gain
3BSE029382R0101 Rev C 3-25
3.12.6.1 Wrap Gain Menus for One Roll, Two Rolls and Segmented Roll
Setting Wrap Gain is described in the following order:
1. One roll. Gain scheduling “No”
2. One roll. Gain scheduling “Yes”
3. Two rolls. Gain scheduling “No”
4. Two rolls. Gain scheduling “Yes”
5. Segmented roll. Gain scheduling “No”
6. Segmented roll. Gain scheduling “Yes”
Figure 3-14. Setting Wrap Gain for One Roll
FastSetUp
WebTension
Presentation-
Menu
SetNominal-
Load
ServiceMenu
ZeroSet
SetWrapGain
> 5 s
AO 1 - AO 6
Miscellaneous
Menu
System-
Definition
ObjectType
DO 1 - DO 4
AI 1 - AI 2
DI
SetWrapGain HangWeight
XXXXXX.X N
EnterWrapGain
XX.XX
HangWeight
[XXXXXX.X] N
EnterWrapGain
[XX.XX]
1. Setting Wrap Gain: One Roll. Gain Scheduling “No”.
To
AO 1
EnterWrapGain EnterWrapGain 1
XXXXXX.X N
EnterWrapGain 2
XX.XX
EnterWrapGain 1
[XXXXXX.X] N
EnterWrapGain 2
[XX.XX]
To
AO 1
HangWeight HangWeight 1
XXXXXX.X N
HangWeight 2
XX.XX
HangWeight 1
[XXXXXX.X] N
HangWeight 2
[XX.XX]
2. Setting Wrap Gain: One Roll. Gain Scheduling “Yes”.
SetWrapGain