ABB PFEA 113 - 3.12.3 Setting Object Type

Tension Electronics PFEA113, User Manual
Section 3.12.3 Setting Object Type
3BSE029382R0101 Rev C 3-17
3.12.3 Setting Object Type
Depending on which load cell combination, LoadCellComb:
•one roll
•two rolls or
• segmented roll
that is selected in menu “SystemDefinition” the following object types are available.
Figure 3-5. Setting Object Type for One Roll
Use up and down keys to select type of object
[ZZ] from list.
1. StandardRoll (two load cells, A and B connected)
2. SingleSideA (only load cell A connected)
3. SingleSideB (only load cell B connected)
When single side measurement is selected the measured signal is multiplied by two and
presented as web tension on display and analog output.
3.12.3.1 Object Types for One Roll
Figure 3-6. Object Types for One Roll
FastSetUp
WebTension
Presentation-
Menu
SetNominal-
Load
ServiceMenu
ZeroSet
SetWrapGain
> 5 s
AO 1 - AO 6
Miscellaneous
Menu
System-
Definition
ObjectType
DO 1 - DO 4
AI 1 - AI 2
DI
SetObject
ZZ
AreYouSure
SetObject
[ZZ]
To
ObjectType
Setting Object Type for One Roll
SetNominalLoad
Roll 1
A
B
PFEA113
AB
Standard roll
Input
C
D
A
B
PFEA113
AB
Single side A measurement
Input
C
D
A
B
PFEA113
B
Input
C
D
Single side B measurement