Commissioning of the KNX function via ABB DCA SmartTouch 10 (from
ETS5)
Product manual 2CKA001473B5343
101
9.8.11 "Scene" control element
A scene can be allocated via the "Scene" control element. The scene starts when clicking on
this element, if this has been so defined. The scenes must first be created by the commissioner.
Setting and selection options via the "Parameter" area of the DCA, see chapter 10.11 “"Scene"
control element“ on page 163.
9.8.12 Control element: "Value slider"
The values of a selected element (group address) can be displayed and at the same time
adjusted via the slider using the "Value slider" control element. When adjusted, the values are
displayed directly updated. This allows values to be sent and received via this function.
Setting and selection options via the "Parameter" area of the DCA, see chapter 10.12 “Control
element: "Value slider"“ on page 167.
9.8.13 "Display" control element
Currently transmitted values from a selected device (group address) can be displayed via the
"Display" control element.
Setting and selection options via the "Parameter" area of the DCA, see chapter 10.13 “"Display"
control element“ on page 171.
9.8.14 Control element "Audio control"
An allocated audio device can be controlled via the "Audio control" control element.
Setting and selection options via the "Parameter" area of the DCA, see chapter 10.14 “Control
element "Audio control"“ on page 190.
9.8.15 "Page link" control element
The following links are possible via the "Page link" control element:
■
on a page created directly via the commissioning tool (DCA) or
■
on the application pages "Door communication", "Alarm", "Timer" or "System settings".
This opens the linked pages.
Setting and selection options via the "Parameter" area of the DCA, see chapter 10.15 “"Page
link" control element“ on page 198.
To Next Page
Loading...
