ABB SmartTouch B/stainless

KNX control elements and application parameters
Control element "RTC control element"
Product manual 2CKA001473B5343
│
144
10.7.7 Display actual temperature
Options: Deactivated
Activated
The parameter is used to specify whether the current temperature is displayed.
10.7.8 Display
Options: Current setpoint
Relative set value
The parameter is used to specify the setpoint that is shown in the display.
10.7.9 Hide temperature unit
Options: Disabled
Activated
The parameter is used to specify whether the temperature unit is displayed.
10.7.10 Unit of temperature
Options: °C
°F
The parameter is used to specify the unit with which the temperature is displayed.
10.7.11 Adjusting the temperature unit via object
Options: Disabled
Activated
The parameter is used to specify whether the adjustment of the temperature unit is made via an
object.
10.7.12 Heating/cooling switchover
Options: Deactivated
Activated
The parameter is used to specify whether the RTC control element can be switched over
between heating and cooling mode.
10.7.13 Fan coil control during heating mode
Options: Deactivated
Activated
The parameter is used to specify whether the fan coil fan is activated during heating mode.