KNX control elements and application parameters
Application "Internal RTC"
Product manual 2CKA001473B5343
277
10.24.142 Fan settings heating
Notice
Only available when parameter "Number of fans" is set on "Heating/cooling via
two systems".
Notice
Additional parameters for "Fan settings heating" are available under "Fan coil
unit settings".
10.24.143 Fan settings cooling
Notice
Only available when parameter "Number of fans" is set on "Heating/cooling via
two systems".
Notice
Additional parameters for "Fan settings cooling" are available under "Fan coil
unit settings".
10.24.144 Fan settings - Level output
Options: According to standard value table
Specify individually
This parameter is used to specify whether the level output is set according to the value table or
individually.
To Next Page
Loading...
