KNX control elements and application parameters
Application "Internal RTC"
Product manual 2CKA001473B5343
271
10.24.122 Temperature limiter
10.24.123 Temperature limiter - Temperature limit of heating
Options: Deactivated
Activated
The parameter is used to specify whether the following parameters are available for the
"Temperature limit of heating".
– Setpoint temperature
– Hysteresis
– Integral component of PI controller
10.24.124 Temperature limiter - Temperature limit of additional heating stage
Options: Deactivated
Activated
The parameter is used to specify whether the following parameters are available for the
"Temperature limit of additional heating stage".
– Setpoint temperature
– Hysteresis
– Integral component of PI controller
10.24.125 Temperature limiter - Setpoint temperature of heating / additional heating stage
Options: Setting option from 20 - 100
The parameter is used to specify the value of the setpoint temperature for "Heating" or the
"Additional heating stage".
10.24.126 Temperature limiter - Temperature limit of cooling
Options: Deactivated
Activated
The parameter is used to specify whether the following parameters are available for the
"Temperature limit of cooling".
– Setpoint temperature
– Hysteresis
– Integral component of PI controller
10.24.127 Temperature limiter - Temperature limit additional cooling stage
Options: Deactivated
Activated
The parameter is used to specify whether the following parameters are available for the
To Next Page
Loading...
