ABB SmartTouch B/stainless User Manual

KNX control elements and application parameters
Application "Internal RTC"
Product manual 2CKA001473B5343
│
264
Activated
If this parameter is activated, a separate object can be used to delete the manual adjustment at
any time. Example of application: Resetting the manual adjustment on all devices located in an
office building using a system clock.
10.24.103 Setpoint adjustment — Permanent storage of on-site operation
Options: Deactivated
Activated
If this parameter is activated, the manual settings for setpoint and, where applicable, fan speed
level, as well as the value of the "Basic load" object, will be stored in the device and re-activated
after a reset. The same applies to the operating mode.
If the device is re-programmed, the stored setpoint values will also be deleted.

ABB SmartTouch B/stainless Specifications

General

Display Resolution	800 x 480 pixels
Mounting	Wall or panel mounting
Material	Stainless Steel
Operating Temperature	-10°C to +50°C
Display Size	7 inches
Resolution	800 x 480 pixels
Protection Rating	IP65
Communication Interface	Ethernet
Protection	IP65 (front)