KNX control elements and application parameters
Application "Internal RTC"
Product manual 2CKA001473B5343
261
Notice
This parameter is only available when the "Send current setpoint" is set on
"Cyclic and during change".
10.24.92 Setpoint settings - Basic set value is
Options: Comfort cooling setpoint
Comfort heating setpoint
Mean value between comfort heating and cooling
■
Setpoint for cooling comfort:
– The device uses the temperature value that has been set via parameter "Setpoint
temperature for cooling comfort" (°C).
■
Setpoint for heating comfort:
– The device uses the temperature value that has been set via parameter "Setpoint
temperature for heating comfort" (°C).
■
Mean value between heating comfort and cooling comfort:
– The device uses the mean value of the two specified setpoints.
The RTC requires a defined basic set value for its function. The parameter is used to specify the
setpoint the device accesses.
Notice
The parameter can only be set when the "Setpoint heating comfort = Setpoint
cooling comfort" parameter is deactivated.
To Next Page
Loading...
