Commissioning of the KNX function via ABB DCA SmartTouch 10 (from
ETS5)
Product manual 2CKA001473B5343
86
■
Switch-off value
Options: Off
On
The parameter is used to set the switch-off value of the proximity sensor.
Notice
The parameter is only available if the parameter "Use approximation to switch on
the display" and the "Use 1-bit output object for proximity function" are activated.
Notice
When activated, the switch-off value is first sent when the panel switches into
the standby mode.
■
Activate communication object "Deactivate proximity" 1 bit
Options: Activated
Deactivated
The parameter is used to activate the "Deactivate proximity" communication object.
To Next Page
Loading...
