INSTALLATION ACTWinPro
Installing ACTWinPro
ACTWinPro is designed to operate either on a standalone PC (ACTWinProLite)
or in a network environment (ACTWinPro).
Note: This application can only be used on PCs on which it has been installed. It
cannot be copied from one PC to another.
To install ACTWinPro, insert the CD into your computers CD driver. If Autoplay is
enabled, the setup application will load automatically. To load setup manually,
select the CD drive from Explorer and double click the SETUP.EXE file.
The setup application will run the installation wizard and take you through the
installation procedure.
ACTWinPro users only
After installation you have 30 days to register the application. Registration may
be done over the Internet, via email or directly with ACT technical support
(telephone 00 353 1 466 2570 or from UK LoCall 0845 300 5204).
Page 7 Access Control Technology
To Next Page
Loading...