ACT ACTWINPRO - Reporting

DATABASE MENU ACTWinPro
The output is activated if the door has been open for longer than a predetermined
period of time. It is reset once the door is closed or when a valid card is swiped.
Door forced
The output is activated if the door is opened without being explicitly commanded
to open by the controller. This would typically occur if the locking mechanism is
bypassed or if the door is physically forced open. It is reset when a valid card is
swiped.
Door opened
The output is activated while the door is open.
Access denied
The output is activated for 2 seconds if an invalid card is swiped.
Access granted
The output is activated if a valid card is swiped. It remains active while the door
relay is active.
Duress code used
The output is activated if a duress PIN code is entered. This is when a number 1
greater than the valid PIN is entered in PIN Only or PIN & Swipe operation.
Exit granted
The output is activated if a valid card is swiped at an exit reader. It remains active
while the door relay is active.
Exit denied
The output is activated for 2 seconds if an invalid card is swiped at an exit
reader.
Follow main relay
While the main relay is active, the Aux relay is also active.
Arm Intruder panel
The AUX relay pulses for the AUX Time when a user with the arm/disarm option
presents a valid card or PIN. This output must be wired into an input on the alarm
panel which signals arming or disarming (usually called keyswitch). If required,
the Arm Intruder Panel output may be toggled instead of pulsed. Turn this option
on by setting the AUX relay time to zero.
Reporting
The reporting box contains various Reporting Options that may be checked or
unchecked to determine what additional events that occur on this door are
recorded in the system event log.
Page 52 Access Control Technology