7351 Series Digital Multimeter Operation Manual
6.7.3 ADC Command Reference
6-23
Measurement Measurement
data memory
ST0 Store: OFF -
ST1 Store: ON -
ST? Reply: ST0 or ST1 -
IRDn, m Readout range setting
n, m: 0 to 19999
(0, 0) -
IRO? Data reading
Reply: See Section 6.7.2, “Output Data Format.”
-
IRPO? Number of measurement results readings
Reply: IRPOdddd
-
IRNO? Data range reading
Reply: IRNOddddd, ddddd
No data: IRNO+00000,-00001
-
ICL Measurement data memory initialization -
Trigger system Start INI Leaves the IDLE state. -
Continue INIC0 CONTINUOUS OFF -
INIC1 CONTINUOUS ON -
INIC? Reply: INIC0 or INIC1 -
Trigger abort ABO Moves to the IDLE state. -
Trigger source
selection
TRS0 IMMEDIATE -
TRS1 MANUAL -
TRS2 EXTERNAL (7351A, 7351E + Option 03) -
TRS3 BUS -
TRS? Reply: One of TRS0 to TRS3 -
Trigger delay TRDn n: 0 to 3600 (seconds) (0) -
TRD? Reply: TRD+d.ddddEdd
(The position of the decimal point depends on the set-
ting.)
-
Sampling count SPNn n: 1 to 20000 (counts) (1) -
SPN? Reply: SPNddddd -
Item Command Description Initial value R6451
To Next Page
Loading...
