7351 Series Digital Multimeter Operation Manual
6.7.3 ADC Command Reference
6-28
Item Command Description
Initial
value
R6451
System
Buzzer BZ0 OFF
BZ1 ON *6
BZ? Reply: One of BZ0 to BZ1 -
Comparator result
buzzer
BP0 OFF -
BP1 The buzzer sounds when the comparator calculation result is FAIL. -
BP2 The buzzer sounds when the comparator calculation result is PASS. -
BP? Reply: One of BP0 to BP2 -
Measurement
data display
DS0 OFF -
DS1 ON
DS? Reply: DS0 or DS1 -
Power supply
frequency
LF0 50 Hz
*5
-
LF1 60 Hz -
LF? Reply: LF0 or LF1 -
Initialization *RST Parameter initialization Z
-
C Device clear
Changing the response
to *IDN?
*7
OID0 The new model name is the response to *IDN?.
OID1 The old model name is the response to *IDN?.
OID? Response: OID0 or OID1
Instrument
information
*IDN?
New model name response
ADC Corp.,xxxxx,nnnnnnnnn,mmm
xxxxx: 7351A or 7351E (Product model name)
nnnnnnnnn: Serial No.
mmm: Revision No.
The new model name response is applied to software revision
C00 or later.
Old model name response
ADC Corp.,xxxxxxxxx,nnnnnnnnn,mmm
xxxxxxxxx: ADCE7351A or ADCE7351E (Product model name)
nnnnnnnnn: Serial No
mmm: Revision No.
IDN?
Header H0 Header OFF
H1 Header ON
*5
H? Reply: H0 or H1 -
Block delimiter *4 DL0 CR/LF+EOI
DL1 LF -
DL2 EOI
DL? Reply: One of DL0 to DL2 -
*4: EOI is a GPIB function. EOI is not output in USB.
*5: This cannot be initialized by the *RST command.
*6: There are BZ1 to BZ4 according to comparator calculation results.
*7: This command is applied to software revision C00 or later.
To Next Page
Loading...
Need help?
General
