ADCMT 7351A User Manual

7351 Series Digital Multimeter Operation Manual
6.7.3 ADC Command Reference
6-27
Calculation PASS condition
range setting
LOP0 Calculation result LO is not specified as the PASS condi-
tion.
LOP1 Calculation result LO is specified as the PASS condition.
LOP? Reply: LOP0 or LOP1
MIP0 Calculation result GO is not specified as the PASS condi-
tion.
MIP1 Calculation result GO is specified as the PASS condition.
MIP? Reply: MIP0 or MIP1
HIP0 Calculation result HI is not specified as the PASS condi-
tion.
HIP1 Calculation result HI is specified as the PASS condition.
HIP? Reply: HIP0 or HIP1
Statistical SIRDn,m Statistical calculation range setting and performing the
calculation
n, m: 0 to 19999
Note:
1. An error occurs if no data exists in the range set
by the measurement data memory.
2. No parameters can be omitted. (0, -1)
(0, -1)
-
SIRD? Statistical calculation range reading
Reply:SIRDddddd, ddddd
Initial state: SIRD+00000, -00001
-
SCNT? Number of samples reading
Reply: SCNT+d.dddddE+dd *2
-
SMAX? Maximum value reading
Reply: SMAXd.dddddEdd *2
-
SMIN? Minimum value reading
Reply: SMINd.dddddEdd *2
-
SAVE? Average value reading
Reply: SAVEd.dddddEdd *2
-
SSIG? Standard deviation value reading
Reply: SSIGd.dddddEdd *2
However, if the number of samples is 1 or less:
Outputs SSIG+9.99999E+30
-
SPTP? MAX-MIN reading
Reply: SPTPd.dddddEdd *2
-
*2: The position of the decimal point in the reply is fixed.
Item Command Description
Initial
value
R6451

ADCMT 7351A Specifications

General

Brand	ADCMT
Model	7351A
Category	Multimeter
Language	English