１２２
22.29 UP/DOWN ref changing time
Range: 0.0 ~ 3000 Sec in 0.1 Hz Sec
Initial value: 10.0 Sec
It can change the time that UP/DOWN reference is respond
When run command is input, VFD can run to initial value without up or down source
22.27 (UP/DOWN up source)
22.28 (UP/DOWN down source)
22.30 (UP/DOWN min value)
22.31 (UP/DOWN max value)
22.26 (UP/DOWN initial value)
22.29 (UP/DOWN ref changing time)
22.30 UP/DOWN min value
Range: 0.00 ~ 400 Hz in 0.01 Hz - frequency
Range: 0.0 ~ 100 % in 0.1 % - PID
Initial value: 0.00 Hz
This parameter works when the
'22.25' (UP/DOWN function)
is 1(Enable)
UP/DOWN can’t operate below the min value
22.31 UP/DOWN max value
Range: 0.00 ~ 400 Hz in 0.01 Hz - frequency
Range: 0.0 ~ 100 % in 0.1 % - PID
Initial value: 60.00 Hz
This parameter works when the
'22.25' (UP/DOWN function)
is 1(Enable)
UP/DOWN can’t operate above the max value
22.32 UP/DOWN ref monitor
Range: 0.00 ~ 400 Hz in 0.01 Hz - frequency
Range: 0.0 ~ 100 % in 0.1 % - PID
This parameter displays UP/DOWN reference value
22.33 UP/DOWN initial value saving
0: Not saving ----- Initial value
1: Saving
Selects that whether initial value going to save or not
To Next Page
Loading...