ICR-1601
205
Change MMI Setting for Accessing
This is the router’s web-based MMI access which allows administrator to access the router for
management. The router’s web-based MMI will automatically logout when the idle time has elapsed. The
setting allows administrator to enable automatic logout and set the logout idle time. When the login
timeout is disabled, the system won’t logout the administrator automatically.
3 times is set by
default
Enter the login trial counting value.
Value Range: 3 ~ 10.
If someone tried to login the web GUI with incorrect password for more
than the counting value, an warning message “Already reaching
maximum Password-Guessing times, please wait a few seconds!” will be
displayed and ignore the following login trials.
The Enable box is
checked, and 300 is set
by default.
Check the Enable box to activate the auto logout function, and specify
the maximum idle time as well.
http/https is selected
by default.
Select the protocol that will be used for GUI access. It can be http/https,
http only, or https only.
The default box is
selected by default
If the https Access Protocol is selected, the HTTPs Certificate Setup
option will be available for further configuration.
You can leave it as default or select an expected certificate and key from
the drop down list.
Refer to Object Definition > Certificate Section for the Certificate
configuration.
The box is unchecked
by default.
Check the box (gzip, or deflate) if any compression method is preferred.
To Next Page
Loading...
