Advantech ICR-1601 - System Time

ICR-1601
207
Memory Usage
N/A
It displays the percentage of device memory utilization.
System Time
N/A
It displays the current system time that you browsed this web page.
Device Up-Time
N/A
It displays the statistics for the device up-time since last boot up.
Refresh
N/A
Click the Refresh button to update the system Information immediately.
5.2.3 System Time
The router provides manually setup and auto-synchronized approaches for the administrator to setup
the system time for the router.
Go to Administration > System Operation > System Time tab.
System Time Information
Item
Value Setting
Description
Synchronization
method
1. A must fill setting.
2. Time Server is
selected by default.
Select the synchronization method from Time Server, Manual, PC or Cellular
Module.
Time Zone
1. It is an optional item.
2. GMT+00 :00 is
selected by default.
Select a time zone where this device locates.
Auto-
synchronization
1. Checked by default.
2. Auto is selected by
default.
Check the Enable button to activate the time auto-synchronization function
with a certain NTP server.
You can enter the IP or FQDN for the NTP server you expected, or leave it as
auto mode so that the available server will be used for time synchronization
one by one.
Daylight Saving
Time
1. It is an optional item.
2. Un-checked by
default
Check the Enable button to activate the daylight saving function.
When you enabled this function, you have to specify the start date and end
date for the daylight saving time duration.
Set Date & Time
1. It is an optional item.
If you do not enable the time auto-synchronization function, you can also
manually set the date (Year/Month/Day) and time (Hour:Minute:Second).
NTP Service
1. Unchecked by
default.
2. NTP Service is
Check the Enable button to activate the NTP service.