Advantech ICR-1601 - SNMP Setting; Enable SNMP

ICR-1601
191
for configuring the "Gateway 1". Only the "UserName1" account can let the "Gateway 1" accept the
configuration from the NMS since the authority of the account is "Read/Write".
 Once a managed device has an urgent event to send, the device will issue a trap to the Trap Event
Receivers. The NMS itself could be one among them.
 If you want to secure the transmitted SNMP commands and responses between the NMS and the
managed devices, use SNMPv3 version of protocol.
 The remote NMS without privilege IP address can't manage the "Gateway 1", since "Gateway 1" allows
only the NMS with privilege IP address can manage it via its WAN interface.
SNMP Setting
Go to Administration > Configure & Manage > SNMP tab.
The SNMP allows user to configure SNMP relevant setting which includes interface, version, access
control and trap receiver.
Enable SNMP
SNMP
Item
Value setting
Description
SNMP Enable
1.The boxes are
unchecked by
default
Select the interface for the SNMP and enable SNMP functions.
When Check the LAN box, it will activate SNMP functions and you can access
SNMP from LAN side;
When Check the WAN box, it will activate SNMP functions and you can access
SNMP from WAN side.
WAN Interface
1.A Must filled
setting
2. ALL WANs is
selected by default
Specify the WAN interface that a remote SNMP host can access to the device.
By default, All WANs is selected, and there is no limitation for the WAN
interface.