ICR-1601
99
Static Routing Setting
Go to Basic Network > Routing > Static Routing Tab.
There are three configuration windows for static routing feature, including "Configuration", "Static
Routing Rule List" and "Static Routing Rule Configuration" windows. "Configuration" window lets you
activate the global static routing feature. Even there are already routing rules, if you want to disable routing
temporarily, just uncheck the Enable box to disable it. "Static Routing Rule List" window lists all your defined
static routing rule entries. Using "Add" or "Edit" button to add and create one new static routing rule or to
modify an existed one.
When "Add" or "Edit" button is applied, the "Static Routing Rule Configuration" window will appear
to let you define a static routing rule.
Enable Static Routing
Just check the Enable box to activate the "Static Routing" feature.
The box is unchecked by
default
Check the Enable box to activate this function
Create / Edit Static Routing Rules
The Static Routing Rule List shows the setup parameters of all static routing rule entries. To configure
a static routing rule, you must specify related parameters including the destination IP address and subnet
mask of dedicated host/server or subnet, the IP address of peer gateway, the metric and the rule activation.
The router allows you to custom your static routing rules. It supports up to a maximum of 64 rule sets.
When Add button is applied, Static Routing Rule Configuration screen will appear, while the Edit button
at the end of each static routing rule can let you modify the rule.
To Next Page
Loading...
