EasyManuals Logo

Agena BIOSCIENCE MassARRAY Nanodispenser RS1000 User Manual

Agena BIOSCIENCE MassARRAY Nanodispenser RS1000
162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #131 background imageLoading...
Page #131 background image
Appendix A Changing the Pin Format 129
USG-CUS-059 Rev05MassARRAY® Nanodispenser RS1000 v2.1 User Guide
For Research Use Only. Not for use in diagnostic procedures.
12. Reinsert the calibrant reservoir onto the dry station by pushing the reservoir down
until it is firmly seated at the bottom of the dry station cutout.
13. Close the main door and tap OK.
Figure A.20 Vacuum Cover Placed on the Dry Station
This figure shows a 6-pin vacuum cover. The alignment is the same for a 1-pin cover.
Figure A.21 Inserting the Calibrant Reservoir
The three alignment pins on the bottom of the
vacuum cover should go into the two dry
station wells circled in yellow (the front right
and back left) and the L-shaped channel
(marked "X").
Vacuum cover
Push the calibrant
reservoir down.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agena BIOSCIENCE MassARRAY Nanodispenser RS1000 and is the answer not in the manual?

Agena BIOSCIENCE MassARRAY Nanodispenser RS1000 Specifications

General IconGeneral
BrandAgena BIOSCIENCE
ModelMassARRAY Nanodispenser RS1000
CategoryMeasuring Instruments
LanguageEnglish