Chapter 3 Methods and Mappings 69
USG-CUS-059 Rev05MassARRAY® Nanodispenser RS1000 v2.1 User Guide
For Research Use Only. Not for use in diagnostic procedures.
Set the cleaning steps
1. Tap the cleaning tab of the Method screen.
2. Tap to select steps in the cleaning sequence (Figure 3.14). To skip a step, remove the
check box next to the step.
NOTE
It is recommended that you do not skip any cleaning steps unless instructed to do so by a Agena
Bioscience Customer Support representative.
Figure 3.15 shows the deck components that perform the cleaning steps.
Figure 3.14 Method Screen – Cleaning Tab
Figure 3.15 Deck Components and Cleaning Steps
First step in the
cleaning
sequence
Last step in the
cleaning
sequence
Ultrasonic wash Rinse station Dry station
To Next Page
Loading...
Need help?
General