Chapter 2 Dispensing to SpectroCHIP Arrays 29
USG-CUS-059 Rev05MassARRAY® Nanodispenser RS1000 v2.1 User Guide
For Research Use Only. Not for use in diagnostic procedures.
To check tank status:
1. Tap the STATUS button on the Main Menu (or any other screen).
.
2. On the Machine Status screen that appears, tap the Page 2 tab (bottom of the
screen).
3. Check the tank status on Page 2 (Figure 2.11).
NOTENOTE
If you are using an external supply tank and the supply tank level (low) indicator is lit, you must fill
the internal supply tank to at least half-full. See Checking the external supply and waste tanks,
page 141.
4. Tap the EXIT button to return to the previous screen.
Performing pin priming
(optional)
In some cases, it may be necessary to "prime" the pins prior to dispensing. Priming the
pins wets the surface of the pins to enable better pickup of analyte solution during
dispensation. Pin priming is usually not required, but may improve spotting performance
in low relative humidity (rH) environments.
Figure 2.10 STATUS Button in the Main Menu
Figure 2.11 Machine Status, Page 2
A bright green light
means the supply
tank is low and must
be filled.
A bright green light
means the waste
tank is full and must
be emptied.
To Next Page
Loading...
Need help?
General