Chapter 3 Methods and Mappings72
USG-CUS-059 Rev05MassARRAY® Nanodispenser RS1000 v2.1 User Guide
For Research Use Only. Not for use in diagnostic procedures.
To change a value, tap it. Tap a new value in the number that pad appears and tap
enter.
Save the settings to a
method file
The selected settings will stay in effect until they are changed, a different method file is
loaded, or the instrument is shut down. Saving the settings as a method file provides a
convenient way to retrieve and use the same settings in the future.
1. Tap the SAVE button in the Method screen (Figure 3.18).
2. In the keyboard that appears, type a name for the file, and tap enter.
3. Tap the BACK button to return to the Main Menu.
4. Tap SAVE in the message that appears (Figure 3.19).
Figure 3.18 Method Screen – Aspirate/Dispense Tab
The SAVE button is available on all three tabs of the Method screen.
Figure 3.19 Saving a Method File
Note: This dialog box always appears
when you leave the Method screen. If no
changes were made to the method file or
changes have already been saved, tap
Discard to leave the Method screen.