Chapter 2 Dispensing to SpectroCHIP Arrays56
USG-CUS-059 Rev05MassARRAY® Nanodispenser RS1000 v2.1 User Guide
For Research Use Only. Not for use in diagnostic procedures.
Wait for the pin array assembly to move to home position (all the way left, forward,
and up).
2.11 Accessing dispense volume data from previous runs
1. On the Main Menu, tap the VOLUME button (Figure 2.56). A list of SpectroCHIP Arrays
which have been dispensed with auto tune enabled will be displayed.
2. Tap the name of the SpectroCHIP Array of interest, then tap open. Data for that
SpectroCHIP Array will appear, including dispense volume for each pad, dispense
settings used, and environmental conditions (Figure 2.57).
Figure 2.56 Access Volume Data from Main Menu
Figure 2.57 Volume Data
To Next Page
Loading...