EasyManuals Logo

Agena BIOSCIENCE MassARRAY Nanodispenser RS1000 User Manual

Agena BIOSCIENCE MassARRAY Nanodispenser RS1000
162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Chapter 1 Introduction8
USG-CUS-059 Rev05MassARRAY® Nanodispenser RS1000 v2.1 User Guide
For Research Use Only. Not for use in diagnostic procedures.
NOTE
On a 6-pin instrument, a 6-pin vacuum cover is installed on the dry station. Do not remove the
vacuum cover. See Figure A.4, page 119 for an illustration of the vacuum cover.
Figure 1.6 Overhead View of instrument
Pin Array Assembly
Contains the pin array
used to load and
dispense liquid; allows
up-and-down
movement.
X-Axis Transport
Allows side-to-side
movement of pin array
assembly.
Y-Axis Transport
Allows front to back
movement of pin array
assembly.
Figure 1.7 Overhead View of Instrument Deck
Ultrasonic Wash
Supply Bottle
Supplies solution to
the ultrasonic wash.
Ultrasonic Wash
Cleans pin array
using ultrasound
through fluid.
Rinse Station:
Flushes pin array
with Type 1, >18.2
MΩ water
Dry Station
Dries the pin array
using vacuum.
SCOUT Plate
Holds the SpectroCHIP Arrays
Microtiter Plate Holders
Calibrant
Reservoir
Holds calibrant

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agena BIOSCIENCE MassARRAY Nanodispenser RS1000 and is the answer not in the manual?

Agena BIOSCIENCE MassARRAY Nanodispenser RS1000 Specifications

General IconGeneral
BrandAgena BIOSCIENCE
ModelMassARRAY Nanodispenser RS1000
CategoryMeasuring Instruments
LanguageEnglish