Chapter 2 Dispensing to SpectroCHIP Arrays 27
USG-CUS-059 Rev05MassARRAY® Nanodispenser RS1000 v2.1 User Guide
For Research Use Only. Not for use in diagnostic procedures.
1. Log in as administrator.
The pre-installed administrator login name and password are given during training.
See page 22 for details on how to log on to the instrument.
NOTENOTE
If necessary, log off the previous user by tapping LOG OFF on the main menu.
The User Setup screen appears.
2. To add a user:
a. Tap the ADD USER button in the User Setup screen.
b. In the dialog box that appears, set the user name, password, and level in the
dialog box that appears (Figure 2.8).
c. Tap the ENTER button .
Figure 2.7 User Setup Screen
Figure 2.8 Add a User Dialog Box
Tap this box and type a user name
using the keyboard that appears.
Tap ENTER .
Tap this box and type a password for
the user name using the keyboard
that appears. Tap ENTER .
Select a user level. See Table 2.2
for information about user levels.