© Agilent Technologies 2001–2003 Agilent 3070 System Installation Manual (MS Windows Version) 2-27
Chapter 2: MS Windows System Installation Reference: System Config File Specifics
NOTE
Changes to the system config file should be
reflected in the standard config file. See Standard
Config File Specifics on page 2-29.
Descriptions of Some Statements in the System
Config File
The testhead name Statement
The testhead name statement in the system config file
identifies the block in the bootptab file that contains
hardware and IP addresses for the System Card and
ControlXT/XTP Cards.
The testhead name statement in the system config file
includes only the modules that are present; for a
four-module system it looks like:
testhead name testhead1 module3 module2
module1 module0
The System Card is represented by testhead1
The ControlXT/XTP Card in each module is
represented by module<n>
Modules are mapped in the hosts file. Using this
information, specific hardware addresses can be
determined in the bootptab file.
The line frequency Statement
In this statement, the unused frequency is commented.
For example, if the system power is connected to 60
hertz, 50 is commented.
NOTE
"Commented" means that the comment character,
an exclamation mark (!), has been placed at the
beginning of a line.
The relay Statement
See Vacuum Control on page 2-41.
The cards <keywords> Statements
These statements identify to the system which cards are
installed and where they are installed.
See Table 2-15 on page 2-43 for available 3070 testhead
cards with diagnostics names, cards <keywords>
statements, pattern applications rates and part numbers.
The cards <keywords> statements can be delimited by
commas (,); a range can be separated by the word "to."
Valid examples are:
■ cards 2, 3, 4, 5 hybrid standard double
density
■ cards 2 to 5 hybrid standard double
density
■ cards 2, 4, 7 to 11 hybrid standard
double density
To Next Page
Loading...
Need help?
General
