© Agilent Technologies 2001–2003 Agilent 3070 System Installation Manual (MS Windows Version) 2-26
Chapter 2: MS Windows System Installation Reference: System Config File Specifics
System Config File
Specifics
This section contains:
■ Introduction, 2-26
■ Location of the System Config File, 2-26
■ Edit the System Config File, 2-26
■ The "Official" and "Actual" System Config Files,
2-26
■ To Repair a Corrupt System Config File, 2-26
■ Descriptions of Some Statements in the System
Config File, 2-27
Introduction
The system config file must match the testhead card
configuration.
Edit the system config file if either the testhead cards or
locations of the testhead cards have changed.
Location of the System Config File
The path to the system config file is:
$AGILENT3070_ROOT/diagnostics/th1/config
Edit the System Config File
1 Login as service3070 (default password is
service).
2 At a BT-BASIC window prompt, enter:
msi btgetenv$ ("AGILENT3070_ROOT") &
"/diagnostics/th1"
3 Enter:
get "config"
4 Edit the file to match the actual testhead card
configuration.
5 Enter:
re-save
6 Compile the changed system config file. See
Compiling the System and Standard Config Files
on page 2-35
The "Official" and "Actual" System Config Files
The "official" system config file is the system config file
as when the system was shipped.
It is contained on a printout shipped with the system,
and can be used as a model if it should be necessary to
customize the system config file.
The "actual" system config file is the system config file
in use which reflects the actual cards and card locations
in the testhead.
To Repair a Corrupt System Config File
One of the sys.config.xxx templates can be copied
from the $AGILENT3070_ROOT/diagnostics directory
and edited to match the actual system configuration.
To Next Page
Loading...
Need help?
General
