© Agilent Technologies 2001–2003 Agilent 3070 System Installation Manual (MS Windows Version) 1-41
Chapter 1: MS Windows System Installation Procedure: Completing the Installation
2 Place the customer's Agilent 3070 software licenses
in Chapter 2.
3 Fill out the Installation and Configuration Records to
reflect the system.
Maintenance Records
If a problem was fixed that warrants a Maintenance
Record, fill one out now.
About ScanWorks
If the testhead is equipped with ScanWorks
boundary-scan, the system config file
($AGILENT3070_ROOT/diagnostics/th1/config)
and standard config file ($AGILENT3070_ROOT/
standard/config
) must be edited to use the
ScanWorks hardware. This is the customer’s
responsibility. See the Syntax Reference User’s manual
for information on the ports... statement. You should
have code similar to this in your config files:
performance port
port 2 100 pin bsi 1
end performance port
Installation Billing Information
Up to eight hours may be charged to Agilent's
Electronics Manufacturing Test Division (EMTD/0900)
for performing the scope of the system installation that
includes:
■ Initial site preparation – two hours.
■ Verifying the site preparation – two hours.
■ Installing the system and completing full
Diagnostics – four hours.
Contact EMTD at 1.800.447.TEST to bill charges above
and beyond this scope.
Do not include repair time on the installation repair
order. Instead, complete a separate repair order for any
warranty repair associated with the installation.
To Next Page
Loading...
Need help?
General
