© Agilent Techonolgies 2001–2003 Agilent 3070 System Installation Manual (MS Windows Version) i
Contents
System Installation Manual (MS Windows Version)
E9970-90001 Rev. H 06/2003
1 MS Windows System Installation Procedure
In this Chapter.............................................................................................................................. 1-1
Referenced Manuals ..............................................................................................................1-1
Tools Required............................................................................................................................. 1-2
Getting Started ............................................................................................................................. 1-3
Verify Site Preparation Complete.......................................................................................... 1-3
Check for Shipping Damage.................................................................................................. 1-3
Check the Shipment Against the Order Before Uncrating .................................................... 1-3
Un-crate the System............................................................................................................... 1-3
Check the System and the Contents of all Crates and Boxes Against the Order................... 1-3
Setting Up the KVM and Support Arms...................................................................................... 1-5
Introduction............................................................................................................................ 1-5
Install the KVM and Support Arms....................................................................................... 1-5
Adjust the Support Arm Tension ......................................................................................... 1-15
Setting Up the Strip Printer........................................................................................................ 1-17
Install the Strip Printer Tray ................................................................................................ 1-17
Install the Strip Printer......................................................................................................... 1-17
Preparing the Testhead............................................................................................................... 1-18
Install the Footswitch........................................................................................................... 1-18
Install the Probe and Probe Cradle ...................................................................................... 1-19
Install the Fixture Pull-Down Label -- Non-English Only .................................................. 1-19
Attach the Site LAN Cable .................................................................................................. 1-20
Powering the PDU and Controller ............................................................................................. 1-21
Supply Power to the PDU.................................................................................................... 1-21
Switch on the Controller ...................................................................................................... 1-21
Configuring the System to a Network ................................................................................. 1-22
Logon as service3070 to Complete the Installation .......................................................... 1-22
To Next Page
Loading...
Need help?
General
