Agilent Technologies EMC Series Programmer's Guide

186 Chapter 4
Programming Command Cross-References
Functional Index to SCPI Subsection
Functional Index to SCPI Subsection
The following table lists the SCPI subsections or subsystems associated with the
instrument function category you wish to perform. The commands listed that begin
with an asterisk (*) are IEEE common commands. These commands, and the SCPI
commands in the subsection or subsystem, are documented in Chapter 5,
“Language Reference,” on page 189.
Function Category SCPI Subsection or Subsystem
ALIGNMENT *CAL?
*TST?
:CALibration
:STATus:QUEStionable
ATTENUATOR see function category: Internal
Attenuation and Source
BANDWIDTH :CALCulate
:INITiate
:MEASure
[:SENSe]:BANDwidth
CONFIGURATION and STATUS *RCL <register>
*SRE <integer>
*STB?
:SYSTem
CONTROL :ABORt
CORRECTED MEASUREMENTS [:SENSe]:CORRection
COUPLING :COUPle
[:SENSe]:BANDwidth
DELETE, LOAD, OR SAVE *SAV <register>
:MMEMory
DEMODULATION [:SENSe]:DEMod
DISPLAY :UNIT
EMI DIAGNOSTICS :MEASure
EMI MEASUREMENTS :MEASure
[:SENSe]:EMI
FREQUENCY [:SENSe]:FREQuency
:STATus:QUEStionable
FREQUENCY SPAN [:SENSe]:FREQuency

Agilent Technologies EMC Series Specifications

General

Brand	Agilent Technologies
Model	EMC Series
Category	Measuring Instruments
Language	English