246 Chapter 5
Language Reference
HCOPy Subsystem
Remarks: This parameter retains the setting previously selected, even
through a power cycle.
Key Access:
Print
Select a Signal List to Include in a Report
:HCOPy:EMI:ITEM:SLISt:PPEak|QPEak|AVERage|LLINe1|LLINe2|
CORRection|UNCertainty|COMMent:STATe ON|OFF|1|0
:HCOPy:EMI:ITEM:SLISt:PPEak|QPEak|AVERage|LLINe1|LLINe2|
CORRection|UNCertainty|COMMent:STATe?
Selection of signal list columns to include in the report. (PK, QP, AVG, limit1,
limit2, correction, uncertainty, comment)
Factory Preset
and *RST: Off
Select a Signal List to Include in a Report (Delta)
:HCOPy:EMI:ITEM:SLISt:DELTa1|DELTa2:PPEak|QPEak|AVERage
:STATe ON|OFF|1|0
Selects delta from limit line values to include in report. For each combination of
limit lines (1 and 2) and detectors (PPEak. QPEak, and AVERage), this command
can be used to include or exclude the delta from the limit for that detector.
Factory Preset
and *RST: Off
Color Hard Copy
:HCOPy:IMAGe:COLor[:STATe] OFF|ON|0|1
:HCOPy:IMAGe:COLor[:STATe]?
Selects between color and monochrome mode for hard copy output.
Factory Preset
and *RST: The factory default is On. This parameter is persistent, which
means that it retains the setting previously selected, even
through a power cycle.
To Next Page
Loading...
Need help?
General
